Diseqc 1.0 setup5/31/2023 ![]() 8th bit is to re retransmission of message because reply have not received of last message. If the 6th bit is 0 then it is command from master to slave and if this bit is 1 then it means slave is replying.If there is requirement for response then 7th bit is 1 otherwise it is 0. Working Of DISEQC SwitchĭISEQC messages are sent in a sequence short burst of 22 KHz tone.Messages are sent in digital bytes.This byte contain 8 bits.These bits can be 0 or 1 for a byte that depends on the information send in signal.įirst byte is called the framing byte.Suppose if the information is like 11100 then it means this is to listen the slave device. So if you are using 4 LNBs then DISEQC Version 1.0 is sufficient.While to steer the dish there is need for at least DISEQC Version 1.2.
0 Comments
Leave a Reply. |